This article appeared inMachine Designand has been published here with permission.
In breakthrough research, engineers affiliated withUNIST(located in Korea’s largest industrial city, Ulsan) have developed a thermoelectric technology to produce power-generating tubes using 3D printing techniques.
Thermoelectric (TE) technologies show promise in enhancing fossil energy efficiencies by generating electricity from waste heat from industrial or automobile exhaust gases. However, typical thermoelectric solutions manufactured in traditional processes do not fulfill efficiency and low-cost requirements. This is especially true for exhaust pipes, noted the researchers.
To address this inefficiency, a thermoelectric tube using a 3D printed ink made of lead (Pb) and tellurium (Te) was created. The researchers explained that metal particles were mixed inside a glycerol solvent to provide viscoelasticity, a status that exhibits both viscous and elastic characteristics.
The tube has a high thermoelectric performance at temperatures between 400 and 800°C. This is also the temperature range of a car’s exhaust gases.
The research was jointly led by Professor Han Gi Chae and Professor Jae Sung Son from the Department of Materials Science and Engineering, along with Professor Sung Youb Kim from the Department of Mechanical Engineering, at UNIST.
Their experimental and computational findings demonstrated that the performance of the power-generating TE tube fabricated from 3D-printed PbTe tubes were an effective strategy to design system-adaptive, high-performance thermoelectric generators.
“Through this research, we will be able to effectively convert heat generated by factory chimneys, the most common type of waste heat source, into electricity,” said Son. He added that the tube shape makes it more effective in collecting heat than a conventional rectangular parallelepiped shape.
Chae reported that the use of 3D printing technology in the production of thermoelectric materials can overcome limits of conventional materials. “The new technology for providing viscoelastic characteristics to 3D printed materials will be used in various other sectors,” he said.
Their work has been featured on the front cover ofAdvanced Energy Materials.
Reference
Jungsoo Lee, Seungjun Choo, Hyejin Ju,et al.,“Doping-Induced Viscoelasticity in PbTe Thermoelectric Inks for 3D Printing of Power-Generating Tubes,”Adv. Energy Mater., (2021).
